NanoESP, no response on AT command.

[Jitp]

Hi,

I received my Franzis Maker kit and I downloaed Arduino 1.6.9. I plug the board using micro USB cable and did initial setup.

I did not receive any response for “AT”. After unplugging and plugging back the board couple time I was able to get get response for “AT”
,but got Error message “ERROR” when I typed “AT+RST”. “ATE0” and “ATE1” came “OK”.

Now I am not getting any reply for any command.

Both D2 and D6 are on, Blue and Red. When i open Arduino D3 is blinking, when I open serial Monitor it turned off.

Help Please.

[Jitp]

Sorry. Found the problem. Needed to upload PO1_serialInterface.

Working now.

[Author]

Posts