Deutsch
Tag Archive: AccesPoint
Day 3: The NanoESP in access point mode
Behind the third door is the jumper wire, which is important for many tests. To prepare for later tests, you can place the supply lines GND and VCC on the outermost lanes. You’ll thereby have better access to these important…
Read more
Day 5: Switching an LED
Today’s program is finally about controlling hardware via the UDP protocol. In this case, an LED is switched on and off with simple commands. You will find an LED board behind the fifth door. The right dropping resistor already was…
Read more
Day 4: UDP bidirectional
In yesterday’s project, the UDP communication was tested in one direction, i.e. from the board to the PC. In this program, the module is set so that communication in the other direction is possible as well, almost like in a…
Read more
Day 3: UDP-Send
In today’s project, data are exchanged between the board and the PC through the WLAN for the first time. The prerequisite for this is that your computer has a WLAN adapter. The UDP (User Datagram Protocol) is used. Another program…
Read more
(Deutsch) Beispielprojekt – NanoESP & Pretzelboard
Sorry, this entry is only available in German.